firmware for reprap mendel prusa control board mac

Firmware For Reprap Mendel Prusa Control Board Free And Very
Firmware For Reprap Mendel Prusa Control Board Serial Port Communication

Parameter: Main Control Chip: ATMEGA256016AU Input Power: 10V 30V Standby Current: 35mA5mA Stepper Motor Drivers: 5 channel Max Hot bed Output Control: 1 channel Heated output control: 2 channel under-current output control: 3 channel Dimensions: 125mm x 82mm Feature: 1, simple to install: Integrated with the mighty function of the Mega2560ramps 1.4 kit, Great reduce the wiring problem, more convenient connection, and more stable.

Convenient to use: TriGorilla motherboard support LCD2004 and LCD12864 without using adapter, and there are two choices for main board power supply, you can choose DC power supply connection or directly from the terminal, it is convenient to use.

Firmware For Reprap Mendel Prusa Control Board Serial Port Communication

TriGorilla use CP2102 chip as a serial port communication, communication not only stable, but also avoid the repeated to install the driver(There will be increased COM port when replacing the traditional 2560 board, so while those people who need to batch purchasing test, the COM increases to a certain value will lead to cant upload the firmware problem.) 3, Excellent compatibility: Firmware can use the same configuration as ramps1.4, the marlin firmware which runs in Mega2560ramps 1.4 kits can directly running in TriGorilla board.

TriGorilla adopts DC - DC step-down scheme design and Recoverable fuse for short-circuit protection, improving the MEGA2560 board serious heating problem, Allowing any power supply from 10V-30V.

Support up to 5 motor drivers, support A4988 DRV8825 TMC2100 driver: Motor drive circuit doesnt integration on the circuit board.

You can change any stepper motor driver you need, easier to operate.

Kossel, Prusa i3, corexy, etc Instructions: Power port: As picture below, there are two choices for motherboard power supply, choose one of them according to you need.

TMC2209 is compatible with many traditional drives and TMC2208 pins.

Its combination of fast current regulation and resonance suppression can achieve high dynamic motion.

StallGuard is used for sensorless return to the origin to prevent blocking.

Built-in power MOSFET can handle up to 2A RMS motor current, with protection and diagnosis functions, can achieve stable and reliable operation.

A simple and easy-to-use UART interface opens tuning and control options.

Firmware For Reprap Mendel Prusa Control Board Free And Very

Drivers can be set up to operate in a noise-free and very precise manner by a single pulse direction, thus achieving an economical, efficient and competitive solution.

Firmware For Reprap Mendel Prusa Control Board Mac